ArjenCNX's latest activity
-
AArjenCNX replied to the thread Custom USB-C powered 8"display for the Apple IIc with STL files and build plan.Best make sure the gap at the hinge is big enough for a layer of paint, without it rubbing against a surface, that would not look nice...
-
AArjenCNX replied to the thread Card Retainer Baffle - PM 7600 / G3 - photo request.Haha, i just drew one up :-) should have checked!
-
AArjenCNX replied to the thread Power Supply of PowerMac 7600 need recapped.Caps needed: - 16V 2200uF 4X - 16V 1000uF 2X - 35V 470uF 1X - 25V 470uF 1X - 25V 47uF 3X - 50V 2.2uF 1X - 35V 100uF...
-
AArjenCNX replied to the thread Power Supply of PowerMac 7600 need recapped.I can already see that IC1/TOP200YAI is dead, R4, the fusable resistor is blown, meaning that IC1 is dead. this is the self switching...
-
AArjenCNX replied to the thread Custom USB-C powered 8"display for the Apple IIc with STL files and build plan.Very smooth, looks nicer than extrusion printing, make sure you add a washer (nylon/plastic) in between the hinge part of the bezel...
-
AArjenCNX replied to the thread 3D printed HDD slots and slide lock for Power Macintosh G3.I have also drawn up the Motherboard supports and the Motherboard clasp as they are also crumbly print with 0.4mm nozzle at 0.1mm...
-
-
AArjenCNX posted the thread 3D printed HDD slots and slide lock for Power Macintosh G3 in Macintosh LC & Performa.Hi there All, I have a Power Macintosh G3 in and the plastics are very crumbly, so i have spend a few hours to make the needed parts in...
-
-
AArjenCNX replied to the thread A Tale of Two Classics.wow, that took a while no doubt! always a joy when they finally do boot up!
-
AArjenCNX replied to the thread Misbehaving LC 575.I have 3 boards with a similar issue, i used the thermal cam to compare good to bad boards, and found the cuda doesnt get warm. also i...
-
AArjenCNX replied to the thread SE/30 noise in video - where do I look next?.Not bad, personally i have 2 hand helds, one from Applent (AT826) it was around the same price. Served me well for 10 years now. and i...
-
AArjenCNX replied to the thread Custom USB-C powered 8"display for the Apple IIc with STL files and build plan.Nice! can't wait to see it work!
