GreenBar0n's latest activity
-
Please can you read through and vote on the following proposition for changes to the board structure by clicking here.
-
GreenBar0n replied to the thread SE/30 Y3 Crystal Replacement Recommendation?.Wondering if my Y3 has been damaged from a leaking cap. My UE10 had four traces severed, I had to remove UE10 and reinstall it to fix... -
-
GreenBar0n replied to the thread Macintosh SE/30 Vertical & Horizontal Bars on Display "Simasima" Repair Guide.Thanks for the detailed explanation. The UB11 Pin6 issue was confusing me greatly, it was the last unknown for the Reset troubleshooting...
-
GreenBar0n replied to the thread Macintosh SE/30 Vertical & Horizontal Bars on Display "Simasima" Repair Guide.So when the Repair guide says Pin6 should be 0V, this is an error in the guide?
-
-
GreenBar0n replied to the thread Macintosh SE/30 Vertical & Horizontal Bars on Display "Simasima" Repair Guide.S1 is perfect everywhere else and throughout the Simasima Repair Guide, everything works except the Sony Sound chips Pin6. Just so...
-
GreenBar0n replied to the thread Macintosh SE/30 Vertical & Horizontal Bars on Display "Simasima" Repair Guide.This guide was the reason I found this site and joined, well done and thank you for this! I wanted to ask about the Reset section, on...
-
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.Hoping the CPU is what's bad. The UE10 DSC was really bad on this SE/30, the voltage line broke and probably four other lines were...
-
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.I used the DMM to look at the ROM slot pins, they are all over the place in voltage, very few are always stuck at +5.05V, but nearly all...
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.The Reset pin F12 on the CPU is functional, it goes from +5.05V to 0 - 0.80Mv when S1 is pressed. The only Reset pins that were...
