GreenBar0n's latest activity
-
Hey Guest, MARCHintosh 2026 is upon us. Check out community projects, join GlobalTalk, and have fun!
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.3D printed the PRAM adapters last night, the metal thumbtacks will be here tomorrow. The print has a positive polarity marking to... -
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.I have purchased a few things from overseas since the tariffs began, none of them were $3 with $60 shipping...
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.Found a 3D printed adapter, should work, going to give this a go instead of paying that ridiculous shipping charge from France to US...
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.Going to go with this PRAM adapter, unless anyone has a better recommendation...
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.Got SE/30 #2's floppy auto inject working. The PO had bent a 'finger' on the rear left of the carrier assembly downwards and into the...
-
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.After 5 hours and only the initial coating in peroxide creme, nearly all of the yellowing is gone now. The one on the far right has...
-
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.Got the 15L Vevor Ultrasonic cleaner today, huge improvement over the 10L model. Where the 10L model took nearly 3 hours to get to 65°C...
-
-
GreenBar0n replied to the thread Fixing the floppy drive of a Macintosh SE without dying.You'll be fine, you sound cautious and that's enough to keep you above ground :). Pretty sure the discharge procedure of the CRT is...
-
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.SE/30 #2 was really yellow, the bezel was worse than the bucket shown behind it. 8 hours of the 10W UV LED light in a box lined with...
-
-
GreenBar0n replied to the thread What's the best way to fix a stripped-case screw hole?.But the CRT would still be loose in that corner, needed to keep that altogether.
-
GreenBar0n replied to the thread What's the best way to fix a stripped-case screw hole?.I would do that with metal but plastic is easier to fix. I won't say the following is the best way to fix a stripped case thread but I...
-
