jcm-1's latest activity
-
jcm-1 replied to the thread "Platinum" PLA for Macs and Apple ][s.ColorFABB is available but: a) it's expensive b) If you are outside the EU, you have to contact them from their contact page and... -
jcm-1 replied to the thread "Platinum" PLA for Macs and Apple ][s.Here's a color comparison. Top is ColorFABB, bottom is PanChroma. Also: look at that print finish. Same printer. Customized, tuned...
-
-
jcm-1 replied to the thread "Platinum" PLA for Macs and Apple ][s.The new version of it is a little warmer on the color. ColorFABB RAL 7044 is an almost exact match. Problems with both. "Gooey" or...
-
jcm-1 replied to the thread "Platinum" PLA for Macs and Apple ][s.Good point. I equate the stuff to a softer version of pre-aged spindler plastic. HA!
-
jcm-1 replied to the thread "Platinum" PLA for Macs and Apple ][s.My spools are always dried and stored in a gasket sealed container with hygrometer and silica gel. :D It's not moisture. The filament...
-
jcm-1 replied to the thread "Platinum" PLA for Macs and Apple ][s.A) it's not as close B) it prints like GARBAGE. It's soft, always stringy and has poor layer adhesion.
-
jcm-1 replied to the thread Need solution for HDI-45 to DB-15 connectors for video out.Maybe on future runs, we can get some of these done. Depending on bulk cost, we may be able to do them for only a couple dollars more...
-
jcm-1 replied to the thread Need solution for HDI-45 to DB-15 connectors for video out.Y'all can snag one of these adapters here! https://jcm-1.com/product-category/hardware/classic-macintosh/
-
jcm-1 replied to the thread Macintosh Plus 1MB oddity (?).Yup, that's just a plain old Mac Plus board. No SCSI mod. I'm thinking it had some sort of cable that would run from the drive, through...
-
jcm-1 replied to the thread Macintosh Plus 1MB oddity (?).Neat machine! Seems to me like it was aftermarket modded to take a SCSI hard drive, and the extra power supply may have been to provide...
-
jcm-1 replied to the thread Compact Mac's feet project.I have updated my product to use new TPE filament. They are softer, squishier, and stickier. YAY...
-
jcm-1 replied to the thread Compact Mac's feet project.The TPU I use is not hard and won't scratch any normal surface. My workbench is pressed fiberboard. I can scratch it with my fingernail...
-
jcm-1 replied to the thread Compact Mac's feet project.The softness of the feet is dictated mostly by the hardness measurement, like Shore or similar. I'm curious what the hardness value is...
