jmacz's latest activity
-
jmacz replied to the thread Macintosh II, BlueSCSI, and termination.FWIW, on one of my SE/30s, I had a similar issue where internal only worked when an external device was plugged in. After much... -
jmacz replied to the thread 3D Printing & MacEffects Appreciation.The wall less one printed fine flat on the build plate (upside down). It printed without supports but the rear mounting holes were...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.I positioned the 4 holes to match the layout of the bottom holes of a standard spinning disk, which is what I believe most of the...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.The wall-less one prints fine with filament 3D printing and the test fit onto a floppy cage was good.
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Here's one that more resembles the stock bracket. There was room to increase the wall thickness and so I did that to ensure it's...
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Like this would be the wall-less version. The LED post is removable to make it easier to print, and it takes a standard 5mm LED. But...
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.@JDW can your MacSD mount from the bottom or does it have to mount from the sides? I'm asking because the walls on the stock drive...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Ok, I will bite. I will try to draft something up this weekend. You basically want stock mount points for a 3.5” drive, stock location...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.LOL
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.That is correct! :) The case is a stock case that was beat up and badly yellowed. I fixed the cracks and then painted it matte white...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.This is one thing I have not modeled. I always took the lazy route. I use ZuluSCSIs and got them with a 3D printed 3.5“ bracket. I then...
-
-
jmacz replied to the thread Quadra 950 PSU options.The following post was what I have been using to do this for my Mac II, IIci, Quadra 700, and now Quadra 950. The article is about the...
-
jmacz replied to the thread Quick question about some parts and an SE/30 reloaded project.My guess is those were what remained of the fuses at F1, F2, and F3.
-
jmacz replied to the thread Quadra 950 PSU options.I just replaced my dead 950 psu with a Corsair HX1200 PSU (puts out enough amps on the 5V rail .. 30A). Fit into the stock psu casing...
