jmacz's latest activity
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Oh interesting... The holes on both the walls of the walled model and the plate of the wall-less model are lined up the same, and both... -
jmacz replied to the thread 3D Printing & MacEffects Appreciation.That's pretty neat. I can't wait for things to settle and the tariff situation to get better understood in the US as it's preventing me...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.I will defer to some of the other folks in this thread as they seem to know their materials well. I have printed brackets in PLA and...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.The test print of the walled bracket was a success. I test fitted it with a spinning disk and the holes lined up properly. I also test...
-
-
jmacz replied to the thread Macintosh II, BlueSCSI, and termination.FWIW, on one of my SE/30s, I had a similar issue where internal only worked when an external device was plugged in. After much...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.The wall less one printed fine flat on the build plate (upside down). It printed without supports but the rear mounting holes were...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.I positioned the 4 holes to match the layout of the bottom holes of a standard spinning disk, which is what I believe most of the...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.The wall-less one prints fine with filament 3D printing and the test fit onto a floppy cage was good.
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Here's one that more resembles the stock bracket. There was room to increase the wall thickness and so I did that to ensure it's...
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Like this would be the wall-less version. The LED post is removable to make it easier to print, and it takes a standard 5mm LED. But...
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.@JDW can your MacSD mount from the bottom or does it have to mount from the sides? I'm asking because the walls on the stock drive...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Ok, I will bite. I will try to draft something up this weekend. You basically want stock mount points for a 3.5” drive, stock location...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.LOL
