jmacz's latest activity
-
jmacz replied to the thread Upgrading Powerbook 190 to 68040 with FPU?.Yup, Eric Woo is legit. -
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Ok, the new models are published. https://www.printables.com/model/1436037-macintosh-se-scsi-drive-bracket...
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Well, I could have been totally unlucky :) possible I got a bad batch or something. But I did see afterwards there were a lot of reviews...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Oh, you found those? :) That was before I gave up on the extensions. I think I had a variant for the Quadra Nubus slot covers also. But...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.When you say "rightmost edge", are you looking at that rectangle from inside the case or from in front of the case? It looks like you're...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.I haven't had luck with those card extensions, at least various ones available on Amazon. A lot of them seem to be slightly off in...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.@JDW I need two measurements: 1.) For the additional four holes on the wall-less model, how far forward you want them compared to the...
-
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.I prefer using hot glue. It dries quick and is easily reversible. Yes, the measurements were taken off the stock metal bracket and...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.Oh interesting... The holes on both the walls of the walled model and the plate of the wall-less model are lined up the same, and both...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.That's pretty neat. I can't wait for things to settle and the tariff situation to get better understood in the US as it's preventing me...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.I will defer to some of the other folks in this thread as they seem to know their materials well. I have printed brackets in PLA and...
-
jmacz replied to the thread 3D Printing & MacEffects Appreciation.The test print of the walled bracket was a success. I test fitted it with a spinning disk and the holes lined up properly. I also test...
-
