JohnCT's latest activity
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Yes, when I flash with the latest version you posted in #775, I get the OSD and I also now get "FW271" in the upper right side of the...
-
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).As far as I know, the camera itself is fine, but the optics are the biggest bottlneck. There are people who replace the lens to gain...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Same - my reflash also says "Type D- WIP" but it's otherwise identical to the original firmware. I just tried the file in #731 and...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I have tried the factory reset in the menu on both the new D and the original D .bins. It says reset successful, but still no change...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I tried on both 8mm and Super, and the adjustments have no effect. The arrows on screen blink, but no changes occur. It's like it's...
-
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).After I posted it, I tried to move the frame and zoom with the software controls. The arrows blink in response to when I hit the...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Thank you so much. Unfortunately, there's something else going on. I followed your instructions and flashed the stock firmware, but...
-
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I have a situation where my H2825 (a firmware D I have been told) won't adjust the zoom or frame. The adjustment arrows blink when I...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I tried a second film, and it's the same way. Question - is there supposed to be a lens in the window of flip up door over the scanner...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Success!! Short version of story > bought Kodak Reels cheap because it needed "SD card reader". I found that the original SD card...
-
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).You can go much lower than 10K ohms. 3.3v at 10K is a current draw of just 0.33ma (for the 3.3v source) from the buck converters that...
-
JJohnCT replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Back in the early 2000s, a lot of flat TV main boards used a SOT23 - 3 pin reset IC that would activate whenever the main board...
