larryc39's latest activity
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Yes, sometimes, the chintzy plastic of the lens mount on the sensor board are just destroyed when you remove the lens (or even from the...
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Finally have the full suite of mods installed on my machine. Smooth Rolling Film Pulleys I did the pulley mod, I already had some...
-
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Also just FYI I refined my SD slot board mount and back cover parts and updated them in the original post.
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I would not try and use heat shrink tubing, it's pretty soft and will add friction unless you can find some of the glossy stuff. Also...
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).1. I'm going to be busy at work for the next week and a half so my chances t play with this are slowing down again, right after I got it...
-
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Ooof I can't keep up with you guys! I thought I checked the stickies but didn't see this model. Thanks!
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).@Deano I was trying to install your printed cover with 0dan0's lens spacers and the extra piece I built to fit my camera board. It...
-
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I found single-piece orderable lens mounts that are the same size as our original. If you're replacing the lens it might be just as...
-
-
Llarryc39 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).After a long long time...I finally have my C-unit modded! I installed a new 18mm spacing M12 lens mount, plastic, and the extension...
-
