luRaichu's latest activity
-
luRaichu replied to the thread How does one go about ordering a blank SE/30 reloaded board?.The newest ones? mlb_reloaded_r5_2024-11-21.zip JLCPCB is the best value one at this time. The minimum order quantity of five boards... -
luRaichu replied to the thread 68kmla MIA.is it this one by any chance? I haven't found any datasets specific to 68kMLA or its forum software on the main listing, while there is...
-
luRaichu replied to the thread 68kmla MIA.who what where why how?
-
luRaichu replied to the thread 68kmla MIA.
-
luRaichu replied to the thread ATTinyRTC: RTC Replacement for SE/30.Can it work on a Mac Plus? Is it as accurate as the original RTC?
-
luRaichu replied to the thread WarpSE: 25 MHz 68HC000-based accelerator for Mac SE.If they're so good why don't you post them here or on the Internet Archive?
-
luRaichu replied to the thread WarpSE: 25 MHz 68HC000-based accelerator for Mac SE.*ahem* "Last seen this week"
-
-
luRaichu replied to the thread TAM - Aux PSU for Expansion Card(s) in Development . . ..Hi, USB PD 3.1 supports up to 240W, should be plenty for a TAM. It can only output one voltage at a time, you would need a power supply...
-
luRaichu replied to the thread Iris Indigo - 12V rail problems.Is there a broken connection inside the PSU?
-
luRaichu replied to the thread To retrobright or not to retrobright?.https://en.wikipedia.org/wiki/Retrobright#Effectiveness
-
luRaichu replied to the thread 68kmla MIA.It's down again...
-
luRaichu replied to the thread PLI Turbo Floppy 1.44 for the Macintosh - SCSI Floppy.It would be very cool if this drive was reverse-engineered and new ones built. 1.44MB floppies on a Plus? The PEEL 18CV8P programmable...
-
luRaichu replied to the thread Discord Weekly Summary.Affix to the end of each of your messages :)
-
luRaichu replied to the thread 2UBG3: Beige G3 2U-Rackmount Build Obsession Revived!.This is what Goo Gone is for
-
luRaichu replied to the thread PCI Riser Design Rework of GitHub PCIe Riser - Howto?.I would prefer hot air... I've never owned a PowerMac and it isn't necessary. Just would like a more precise mechanical specification...
