robin-fo's latest activity
-
robin-fo replied to the thread Can new PLCC chips be programmed for the SE/30 ?.The Sony SND chips are the two DIP ICs at UB10 and UB11. They are mainly interesting because they trigger the initial reset of the... -
robin-fo replied to the thread SE/30 Reloaded Board - First Test.When you hear a death chime, your Mac is actually executing code, which is very good so far!
-
robin-fo replied to the thread SE/30 Reloaded Board - First Test.Did you already check the PSU voltages? They tend to be a bit weak with the original PSU (even recapped ones). My SE/30 refuses to boot...
-
robin-fo replied to the thread SE/30 Reloaded Board - First Test.Btw. I wrote down the story of my board here: https://tinkerdifferent.com/threads/wtd-se-30-reloaded.1817/post-15366
-
robin-fo replied to the thread SE/30 Reloaded Board - First Test.Where are you located? Maybe there is someone nearby with a known working, socketed board where you could test your GLUE? When my board...
-
robin-fo replied to the thread SE/30 Reloaded Board - First Test.That‘s just one of many, many possible causes :/
-
robin-fo replied to the thread SE/30 Reloaded Board - First Test.In my case, it (pin 11) was shorted to pin 10 or pin 12. But it would really have surprised me if be both did the same mistake… Do you...
-
-
robin-fo replied to the thread SE/30 Reloaded Board - First Test.This is something I also had to go through with my first Reloaded board. I was in the same situation… It turned out to be a short of the...
-
robin-fo replied to the thread Networking with a PM6500/300 and a Mac SE/30.How are you intending to do File Sharing? Using AppleTalk or TCP/IP? I‘d strongly discourage you from using TCP/IP when using LocalTalk...
-
robin-fo replied to the thread Networking with a PM6500/300 and a Mac SE/30.How do you bridge Ethernet and WiFi? Some bridging software doesn‘t correctly handle AARP packets, preventing AppleTalk communication...
-
robin-fo replied to the thread Agilent DSO3102A - looking for firmware.I‘d analyze that RGL file and check if the raw binary (or something equivalent) is hidden inside. Can you upload the corrupted firmware?
-
robin-fo replied to the thread 3D Printing & MacEffects Appreciation.Same with Mouser btw.. 🙃
-
robin-fo replied to the thread Playing with a Recreated TechStep.Do they have original ROMs? 😉
-
robin-fo replied to the thread Mac SE/30 bad condition.Transplanting the components to a newly fabricated circuit board is your only option (if you are good at soldering). Otherwise, you can...
-
robin-fo replied to the thread Mac Classic - available sockets for MicroMac Performer?.There is no problem with the availability of PLCC sockets in general. You just need one which sticks on the non-socketed, soldered PLCC...
