trag's latest activity
-
Ttrag replied to the thread Flashing AEC6280 for Mac use.I had an Adaptec 3940U I converted way back when. Desolder/solder the PLCC32 EEPROM. Didn't work, until some nice fellow recommended...
-
Ttrag replied to the thread Flashing AEC6280 for Mac use.Yes it should. Did you clean up after soldering the resistors? Even if there's no solder bridges, residual solder flux can cause...
-
Ttrag replied to the thread Color Classic Flyback Replacement from LC5xx.You might try shopping on this page...
-
Ttrag replied to the thread Flashing AEC6280 for Mac use.I don't have an answer to your question but am also interested in the solution/trouble shooting. I will contribute that you should...
-
Ttrag replied to the thread Tango 2 without drivers installed is hanging my 6360 during Happy Mac phase of boot. Does that make any sense?.DId it boot once and load drivers? Sometimes, if the Mac is not shut down, but restarted, the drivers will stay in memory. There...
-
Ttrag replied to the thread VRAM - more speed, or just more colors?.I have not done the testing in practice. In theory, it depends on the card. While one would expect it to just give one more...
-
Ttrag replied to the thread Signal RCST# On Beige G3 ROM Module?.Never mind. CE# of the chips is tied to pin 115 on the DIMM. Grackle (MPC106) has two RCS signals, RCS0 and RCS1 and the former goes...
-
TAnyone know what this signal does? It's connected to pin 35. It's shown on this schematic (page 6)...