Recent content by VicNor

Keep on reading... "Still, the floppy would get stuck/stops half way when ejecting." Yes, I lubricated the drive in first time in July, then again in November because I got the tube with silicon grease, and again just recently. I cleaned the old lubricant off with an alcohol wipe and applied...

Yeah, that's why I swapped the entire gear box assembly to one from another drive - to eliminate a potentially damaged motor or residual gear teeth - and yet still got the same issue. I guess that I should try to move the SE's floppy drive gear box with the new gear to another drive to make sure...

My favorite SE has a floppy drive issue. That little cheese gear in the gear box finally broke. Thankfully I had a couple on order since the same gear broke on my Plus literally a month earlier. I cleaned the gear box on the SE's floppy drive, lubricated it with silicon grease - i've used...

I've replaced the second soldered on battery as well and monitored the battery level over time. 10-Sept-2023 upper --- lower 3,11 V 25-Oct-2023 upper 3,235 V lower 3,096 V 24-Jan-2024 upper 3,242 V lower 3,068 V Since I installed a second CR2032 holder, the battery drainage seems to have...

Sign me up

I just finished swapping the orginal PSU fan for a Noctua (80mm, 12V DC, ULN) on my original and non-upgraded Macintosh II. When I did a smoke test the computer was dead as a dodo. The batteries read 2.48V (upper) and 0.87V (lower). I bought this computer from a friend and it was recapped last...

What?! :O Pics or it didn't happen

Fascinating problems. I got a SATA card coming soon for my G3, so I'm following this with great interest. Also, I believe that OS X 10.2.8 is the latest version that the Beige G3 will accept without any XPostFacto mods due to Open Firmware limitations. Installing OS X on these machines seems...

I was surprised that I found my old Toshiba T1100 Plus at my parents during Christmas holidays. I thought that it has been lost! I bought this computer maybe 15 years ago from a high school friend. I think I paid something like 500 SEK (~$50) at the time, and I remember that it felt like it was...

Introduction The need to backup your old hard drives shouldn’t be underestimated. Especially on a computer that’s full of old memories. The hard drive on an IBM PS/2 (Model 56SX, in this case) is a bit special compared to other PC compatible computers. First of all, it’s a SCSI hard drive so you...

By chance I've found an IDE to SATA adapter that works with the Power Macintosh G3's slower IDE bus, ie an adapter that supports UDMA mode 0. It's a cheapo adapter from Amazon. Most of the time the information on Amazon about the adaptor boards are subpar at best - and inaccurate at worst. The...

I guess that's a lot more likely than a genuine bug. 😅

Seems like you've found a genuine bug in the compiler

Pascal is amazing! Unfortunately I've only experienced Borland's Turbo Pascal on CP/M and DOS systems. That said... The code looks fine, but I would like to see a semicolon after the WriteLn statement - but I recall that ISO dialects of Pascal is OK to skip it before an End. Are there maybe...

I've completely forgotten about these! I got a regular SATA SSD (connected with adapter) in my iMac G3. But I'm afraid that this beast might be too fast for a PwrMac G3 Desktop as the computer only supports UDMA mode 0. I suspect that these fast devices only go down to 33 or 66 MB/s in...