Search results

reminds me of a macintosh ii style case

2GB. But OS 9 must be installed on the first GB

I feel like blue with the translucent would look better. Might make it look like a high(er) end version of the iMac

yeah it might be bad, see if you can figure out what value the potentiometer is to change it

I think there is a sub brightness potentiometer inside the Mac SE that should make it so you don't have to turn down the brightness to not see lines

it uses Intel's integrated HD Graphics 3000, so it's very middle of the road, decent for media playback, not for gaming

it should be possible as long as you go for a same-generation chip, which might give you the same performance as a mid 2011 Server Mac Mini, like I have

Tantalum capacitors are good for longevity, the Quadra 700 used them for all its capacitors, and lots of them are still going strong today. I may be biased because that's what my LC III was recapped with, but as I said, longevity and in some cases they may never need to be replaced again unless...

I wonder if it's possible to optimize that enough to make the 68000 emulation into 68010 emulation or have it emulate an 020 or 030 (probably at 16MHz or lower)

according to an old website, the AT power connector part number is MOLEX 15-48-0106 X2

idk why, but something tells me it's similar to the motherboard connector for IBM ATs

this could be the solution I need for a Thirtieth/fortieth anniversary macintosh, I'm planning on building a sleeper PC with a mini PC with a 9 inch touch screen inside a macintosh classic chassis

SE/30's are picky about their RAM, but also make sure there are good connections between the CPU, ROM, and RAM

I'm pretty sure macs only accept EDO memory, they might not like FPM, and parity doesn't matter

that's an indication that the power supply is being short-circuited, so I'd say check the board for shorts and try recapping it

try reseating the ROM, or try putting deoxit on the RAM and ROM sockets and see if the behavior changes

This might only apply to the Macintosh Classic analog boards, but there might be a potentiometer to fix these voltages, but I'd also recommend checking the resistors and seeing if their resistance matches their markings

did you put MODE32 in the extensions folder?

I'm pretty sure MODE32 can only be run on system 7.1 and never, as older versions don't have support for 32-bit addressing, afaik

Rifa capacitors can be replaced by any X or X2 rated capacitors