I'm restoring a couple of original Disk II drives which have rusty bottom screws and melted feet. I had a hard time finding documentation about their specs, so I'm posting this for anyone who needs the info in the future.
The rubber feet are 3M SJ-5023-BLACK. They're 2cm square at their base, about 7.5mm high and taper to a smaller square.
The 4x black case screws are #6-32 1/4" long black oxide pan head screws. Yes, not metric. These are the same specs (other than the finish) as typical PC case screws.
The rubber feet are 3M SJ-5023-BLACK. They're 2cm square at their base, about 7.5mm high and taper to a smaller square.
The 4x black case screws are #6-32 1/4" long black oxide pan head screws. Yes, not metric. These are the same specs (other than the finish) as typical PC case screws.
