Latest activity

Please can you read through and vote on the following proposition for changes to the board structure by clicking here.

What's new New posts New resources New profile posts Latest activity

M
Mark_W replied to the thread (2) Macintosh SE/30's - Full Restoration.

Btw this should be the correct position for t2 marker, to measure the end time of a complete cycle: Assume 50% duty cycle, the...
Thursday at 6:53 AM
chuma posted the thread Are these ventless electrolytic caps bad? in Soldering and Repair.

I'm having two strange issues with my Sharp PT-9000: I can't get a good read from the resistive touchscreen, and the serial port sends...

Thursday at 6:44 AM
colinlm replied to the thread SPIISD V2 has been released.

If by "This SmartPort card" you mean the SoftSP, yes, it works with Fujinet as far as I know.

Thursday at 6:36 AM
G

GerrySch replied to the thread SPIISD V2 has been released.

Hi Guys, does this SmartPort card work with FujiNet? FujiNet uses the SmartPort on the IIgs and IIc+ directly so if this card is...

Thursday at 6:28 AM
G

GerrySch replied to the thread [2GS] Using SCSI drives.

Well, let's clarify a few things. First, the priority of drives on the SCSI bus is 6,5,4,3,2,1,0 with the SCSI card being 7. So with...

Thursday at 6:09 AM
GreenBar0n replied to the thread (2) Macintosh SE/30's - Full Restoration.

Using a cheap DMM with the Frequency Counter function, where there is no adjustable settings like an O-scope, you'll still get 1.305MHz...
Thursday at 3:38 AM
Volvo242GT posted the thread What did you do to you computer today? in General Chat.

Haven't seen a thread, like the ones over at the other forum, so figured I might as well get it rolling. About 30 minutes ago, decided...

Thursday at 2:44 AM
phunguss replied to the thread Dead G4 Cube.

If you can't repair the stock PSU, you may be able to fit any other PSU inside the cage, so you retain the original look. Just...
Thursday at 2:19 AM