Latest activity
-
Certificate of Excellence replied to the thread G4 iMac and its intense heat. A brainstorm..Would they be powerful enough to kick open the drive flap though? I have a few external slimlines but the ones I have really just pop...
-
wottle replied to the thread Apple Lisa 3d Case Project.I must be misunderstanding what you are saying. The front piece is ~18" wide The full width of the Lisa assembled is 18.75". The... -
-
Trash80toG4 replied to the thread Apple Lisa 3d Case Project.The front bezel (only Little Bit of Lisa in my collection) is your print limit factor. If you angle just that one part to max size in... -
phunguss replied to the thread Apple Lisa 3d Case Project.Well, if an iPad 1/2/3 at 9.7” is too large for a smaller print, we could try an iPad Mini 1/2/3/5 at 7.9”, but working controller... -
Sideburn replied to the thread Lead Time for JLCPCB Order?.My last order that just arrived yesterday was through JLCPCB unpopulated. Looks like they are a better option that PCBWAY for that case... -
xc68000 replied to the thread BlueSCSI v2 Pico - Low cost, open hardware, fast SCSI device!.awesome work! For v3 would it be possible to include an external antenna connector for the scsi/wifi feature?
-
PPC_505 replied to the thread Sat. Aug. 1st: ABQ Retro Computers Summertime Meetup.Albuquerque, New Mexico. -
Garrett replied to the thread 4MB Macintosh II & IIx 30-pin SIMM's.I made a set of these ~1yr ago and they never worked. Thankfully I did select 1.2mm thickness (still had to shim them a little for good...
