0dan0's latest activity
-
Hey Guest, MARCHintosh 2026 is upon us. Check out community projects, join GlobalTalk, and have fun!
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Just short RST to GND, and TX on the main board goes to TX1 on the Nano, same for RX to RX0 and GND to GND. -
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Great post. I have stopped using the 3mm F-stop change, while it does make focusing easier (not required), and it does add some...
-
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).It is probably okay. I didn't follow the guide exactly, and used whatever I had around.
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).The existing USB port has a different function, it is not connecting to the debug interface that's on the main board. I just added...
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Thank you. I have attempted to get an H2825 model from eBay, but many sellers will not respond to enquires about serial number (even ask...
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).If you can add the serial port, then you can dump the firmware, this must be before any update attempts (if you want exactly what your...
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Yes, that would appear to be type D. Through which seller do you buy this?
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Anyone want to sell me their H2825 unit?
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Now for the weirdness of D2825 units. This is different firmware (then I have seen, doesn't match any of @Mac84 originals), but it only...
-
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).FFF Infill - Defaults are fine as this is so small it will so near solid anyway Layer - 0.1mm (will help to have a fine print) Material...
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I was about to confirm these offset with the D2825 unit I just relieved. However, it seems to run fine on Type B firmware. Have you...
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).Yes, this has all been explained in detail in the original thread (hours for reading for you.) This image is from Feb 2025...
-
-
0dan0 replied to the thread Hacking the Kodak Reels 8mm Film Digitizer (New Thread).I have used a dremel too, it will work. 3D printing a new camera housing is something I started to design, never got far on that.
