Recent content by mmaseda

Best I can tell LapisColorServerPDS3017.sit from MacintoshGarden is the driver I was using. That’s the only one I can find that I downloaded. Unfortunately I don’t have a SE/30 I can test with anymore. I converted mine to use the Micron Xceed Color30 with the internal grayscale neck board.

Yes, I was able to changes resolutions on my 24. I’m away on a trip until Tuesday but I pretty sure I got one of the drivers off the Macintosh Garden to work.

I have the same board as you so I’ll be following this thread. One thing I notice in the pictures is the 24X has all the jumpers removed in the upper left corner.

Glad to know someone else has seen this. It’s something that if you’re not looking for you might not notice. One thing I might try sometime is installing some ferrite beads on a Sony supply and see if that makes a difference.

I finally got around to installing a TD Design power supply yesterday. This is based on 4 MeanWell modules. Worked fine. Display showed no signs of those horizontal bars. At this point I think done working on this. At least in my case and in my environment I can conclude the problem I...

It doesn’t appear to be anything generated from within my home as I have shut off all the breakerexcept the computer. I just finished my spectrum analyzer testing. The Sony supplies generate a large frequency spike at around 38.7 kHz with subsequent harmonics at 77 and 115 kHz. I suspect I’m...

Beat you to it. Also tested with a SE SuperDrive. Same results. I’m going to break out the spectrum analyzer today and look closely at the AC artifacts on the 12 volt sweep rail. I already looked with a scope and didn’t see much difference except the Sony appeared to show a little more noise.

Tested with multiple logic and analog boards.

I have 3 Sony power supplies that I used for testing of with 2 were recapped. I also have 3 Astec power supplies of which 2 were recapped. Always the same result. I’ve also verified that there is no interference being generated within my house and I have thrown all the breaker in my house and...

Yes, all rail voltages were fine. I also scoped all the rails and the Sony supplies do have a higher amount of high frequencies noise on the 12 volt sweep supply but not significantly more than the Astec. I’ll just use an Astec supply for now since it works fine. I’ll probably in the future...

Yes it was fully recapped. I tested with 3 different Sony power supplies of which 2 were recapped. Results were always the same. Also I tested with multiple logic and analog boards that had also been recapped. Bottom line those horizontal lines were there when Sony power supplies were used...

Since nobody else seems to have the problem I just tell you what I found. Turns out to be an issue when using a Sony power supply. Don’t see the problem with Astec supplies. Have tried multiple Sony and Astec supplies on several different computers and the problem is always there with the...

Thanks but that isn’t the problem. I can recreate this problem on multiple computers each with a different logic board. At this point I’m just trying to see if anyone else has every noticed the problem before.

I’ve been working for a while trying to determine the cause of very faint horizontal lines that move from the bottom to the top of the CRT every few seconds. While I can see them perfectly with my eyes I’ve had a hard time documenting them in a photo or video. Here is my best attempt to...

Received the package today. As I expected they tossed the complete neck board and only shipped me the harness. Luckily a great friend of the retro Mac community is sending me a blank PCB and I’ve already sent in a parts order to Mouser. Guess I won’t be doing any more business with Buyee. Manuel