Search results

Hello everyone I have an SE/30 that has had some work done, it appears previously recapped and looks to have trace repair done as well. Well at first everything went well until about 20 minutes after each use give or take, the computer would go black on the screen and then when you go to power...

So I used the stock LED I wired the red to the 3.3 pin on the top board and the black to the GND pin on the top board. The cable connector was too short so I used DuPont connectors to extend them.

Thank you.

I'm trying to find some on eBay but can't, wanna point me to your seller?

Trying to max out my SE/30 with 128MB or ram, is there anywhere where this can be purchased?

Thanks, can't believe I missed that we are all up and running now.

I have a BlueSCSI for my SE/30 and want to hook up the HDD activity light to it what pins on the BlueSCSI hook to the HDD activity light?

That's flux

Nice now all you’d need is a ccii badge and it’s basically complete.

C93 should be replaced most likely leaked

That'll be fun at least it won't be removing one.

Not familiar with these at all so have no clue lol.

LOL I missed that ^^^^ he's right.

Should be potentiometers to adjust the color drive for green, blue, and red (seen as pink sometimes) probably somewhere on the analog board, have some photos you can provide?

C120 and C194 and the other obstructed by the cable check those caps on almost all Hard drives manufactured by Apple that has had those I've had those fail.

Hmmmmm Rominator in a iivi/iivx?

Not familiar with Newtons but I can try and help, do you have photos of the logic board?

Hey there if you trust me I'll cover shipping both ways to get the ROMs from these and then send them back.

Usually bottom row of SCSI is ground, one sec

Should be able to just run it to ground I’d say tap into a SCSI ground pin