Search results

I found one on ebay last year. Paid around $375 USD + ship. Definitely not a casual purchase, but after 30+ years of cheaping out on programmers it was time to eliminate aggravation from my life. I'd also say the same thing about my Hakko FR-301 vacuum desoldering tool. Worth 10x what I paid...

There's been considerable online discussion about programming ATF... parts with low-cost programmers. Seems to be hit or miss as to whether Atmel parts are properly handled. After some early bad experiences with cheap programmers I picked up a used Dataman 48Pro+ which covers just about any...

Unfortunately, the vendor will not ship Mitutoyo products to the US. We're too busy winning I guess.

If you can clean out that via (left side of cap) it should be a straightforward fix. Thread a short length of #30 wirewrap wire down through the via and tack it to one side of a replacement cap. Be sure to remove the remains of the old cap lead on the right pad!

The area around UD8 and UE8 seems particularly prone to trace damage on SE/30 boards. It's hard to tell (may be lighting), but there appears to be corrosion on the pins of those chips. Highly recommended to remove them for inspection. You could also start by checking point to point with...

I think the "other" Mac site has shuffled off this mortal coil. I feel really bad for folks caught in the midst of buy/sell transactions...

Thanks for clarifying!

Unlike a lot of older machines, the Nextstation (Greyscale) '040 does not have an external switch to select between twisted pair and BNC connector. Is it autosensing, or is there a parameter or jumper change required?

Thomas gets busy at times, but always responds eventually. Good guy - honest and talented!

But, if you are in the US keep in mind that most of the EU has stopped forwarding packages with US addresses. Something about "winning", I think?

You may have a fractured or digested pin on one of the ICs.

I find it's much simpler and safer to remove the entire "top" (load) assembly before accessing the heads. There's a great video on YouTube that walks through faking a diskette load to collapse the loader, disconnecting tension coil springs on the sides and lifting it clear.

Did you recap the analog board as well? If so you may have inadvertently broken the vertical circuitry. In particular, examine the height pot and surrounding area.

Earlier this week I did the same thing to one of my SuperDrive mechanisms. After a bit of shameful language, I realized the little coil spring inside the head assembly had several notches available to increase head pressure. Moving it up to the next (higher) position was enough to do the trick...

Are there any free hardware projects to build soundbox work-alikes?

I've found a post that outlines the default video mode in great detail. What I'm curious about is if the machine pays attention to sense signals from the monitor such that alternate resolutions are possible. The 13W3 connector carries signals for this purpose.

A network capable device gives your Mac a network connection.

BlueSCSI / ZuluSCSI wifi provides a network interface that pretends it's a DaynaPORT SC (SCSI). Setup is quite simple: Configure the Blue/Zulu with the name and password for your Wifi access point and install the Dayna driver. Note that it's TCP/IP only and does not pass AFP frames. One...

Here's a 3MF file if anyone wants to spin their own.

The larger "GDSTime" fan does a great job. I printed a simple adapter to mount it in the original fan location.