Search results

Oooh I do need a 1xx series battery - is that using the case design from thingiverse??

Ah, what slot do you have the video card in? They're VERY picky about that.

Birdseed would be worth it on the underside, i think. The SE/30's that @This Does Not Compute made were about £50 to £60 with birdseed so an extra tenner for a much larger board i think would be worth it.

Oooh - but do all 4 ports on the card work, or can it only address 2?

Don't forget when overclocking to set the SCSI clock to /2 isntead of 1:1 ratio :)

There's DigiKey as well, but honestly, once the order is over £32 iirc, the shipping is free anyway.

Ah, another UK person, welcome! :D Personally, i use mouser.co.uk - i'd follow the guide that @JDW has here: There are SOME differences however, in that the international board has double the amount of large caps. That being said, the safety caps are the same.

Yes.

Zane - given that Xilinx have announced the discontinuation of the entire XC95xx line of CPLD's, is this now going to require re-implementation in an FPGA? Looks like CPLD's are not long for the world, now, as there's no plans to directly replace the XC95 series with any other CPLD. The ones...

Correct - it was for Burn-In only.

Oh... Well now I have a dilemma - as in my second semester of my first year of Uni, I upgraded to an Athlon 64...and later, an Opteron 146...then an Opteron 170. I came across this Asus A8N board (nForce 4) with PCIe support. I also happen to still have my XFX 7600GT from way back then, too...

One thing that should be very clear to people is that these projects are often being done in spare time - not active, commercial products. Developers of these things are just as human as the rest of us - personal life often gets in the way. Personally, i've not done any reverse engineering or...

This PDF is attached in our resources section.

I mean, i've seen a lot worse - honestly, pull the board out and give it a good cycle or two in an ultrasonic cleaner to properly get rid of the filth. It may need some parts reflowing afterwards, as the corrosion has attacked the component legs.

I've not had a chance to have a look at my component selection until today, i'll see what i have in stock - also, for clock signal generation - do you have any spare 4-pin DIP frame Oscillators to hand to generate a fixed frequency which would be suitable? IIRC i sent you some 15.6672MHz ones...

As with the other thread that has been raised, this issue will be discussed in the upcoming board meeting - any amendments will be announced after this.

And more meaning - used in things like the IIci, IIsi etc - the 75175 is pretty ubiquitous in earlier 68k macs.

This issue will be discussed in the upcoming board meeting - any amendments will be announced after this. We recognise that along with a lot of policy - we do need to sometimes flesh out or amend previous guidelines. Thank you to @badferday for raising this - we value our membership giving us...

What does jlcpcb quote for them with standard green, but ENIG finish instead of HASL?

OSHPark is US based...but prepare to have your wallet reamed. JLCPCB is who i used for all of my Classic and SE reloaded board runs. The latest SE/30 reloaded board run of 50, was done by JLCPCB.