PowerBook 100 after 30 years...

MB.68k

New Tinkerer
Jan 25, 2026
12
17
3
Belgium
Found a PowerBook 100 bundle at a local second-hand store, obviously not working.

Problems: Dead power supply. After opening using the "vise method", found intact fuse but multiple grossly leaked caps. Will repair later, switched to another power supply for now. Disk does not seek. It spins up and makes few clicking sounds, but then gives up. Sometimes even spins down. Display mostly dark, nothing appears. Top side quite discolored, brown rather than grey. Rubber screw covers underneath melted into a goo. Floppy drive immediately ejects disks.

Positives: Backlight sometimes appears. Battery did not leak, blow up, or anything like that. PRAM batteries also did not explode, two of three even showed reasonable voltage. There is a 2 MB RAM expansion bringing the total to 4 MB. Floppy drive ejects disks.

Took apart the Conner 40 MB CP 2045 drive (voiding the warranty) and unstuck the arm. Could not find a rubber bumper which one should cover with Kapton tape to prevent sticking. Maybe this model did not have one.

Many caps on the logic board and even the one on CPU board visibly leaked. Replaced the ones that I happened to have, i.e., five 47uF and six 10uF surface mounts, and three 100uF through holes.

Impatient enough not to wait for other replacement caps, I put everything back together and it started just fine. It appears to have been very lightly used, and not at all since 1992. Floppy works fine, and now I have a pristine set of PowerBook French-language manuals to read.

System 7 media, System 7 Tune-Up, and ClarisWorks were part of the bundle. It also came with StyleWriter power supply (dead fuse easy to replace), serial cable, and software, but no StyleWriter.

All in all, very happy with this haul! Will order the remaining caps sometime.

IMG_0301.png