PowerBook Duo Center Clutch Cover

  • Nominations will close March 25th. If you'd like to join the board and influence how TinkerDifferent runs in the next year, put your name in now!
  • Hey Guest, MARCHintosh 2026 is upon us. Check out community projects, join GlobalTalk, and have fun!
jmacz

jmacz

Tinkerer
Mar 21, 2025
87
96
18
Wrapping things up on a 3D printable model of the PowerBook Duo center clutch cover. Once I complete finishing the exterior, painting it, and test fitting it one last time, I will share the model on my Printables account (link in my signature).

CenterClutchCoverDesign.PNG


IMG_3013.JPG


IMG_3014.JPG


IMG_3015.JPG
 
  • Love
Reactions: Garrett
jmacz

jmacz

Tinkerer
Mar 21, 2025
87
96
18
Did not have any layer shift issues. Came out fairly smooth with the only major sanding required being on the end that was attached to the plate due to the brim. :) Went vertical with the print in order to have the layers going up/down on the clips for added strength.
 
You must log in or register to reply here.
Top Bottom