Powermac G4 AGP clip stl

[DavidUrban]

I have a Power Mac G4 Quicksilver, and when I went to remove the graphics card, the clip that holds the card in snapped and broke further when I tried to remove it. I want to 3D print a new one but can't find an STL file for it. I am not proficient in modeling one, so I was hoping someone has made one.

 

[phunguss]

I never liked the AGP tabs... if you have a screw on the io plate, it should stay in place fine without the tab.

Some motherboards have what looked like a clip that went around the entire AGP slot. I am not sure if that is even removable (likely some tabs at the lower edge of the connector). Closest thing I can find is this item, but no 3D files.

 

[DavidUrban]

That looks like what I am needing. Not up for spending money yet for one. Hoping someone has a print file.