Latest activity
-
JDW replied to the thread 3D Printing & MacEffects Appreciation.@caver01 So the question is, how similar is that Printable model to yours, and should he use your enlarged version instead? -
DDave928 replied to the thread 3D Printing & MacEffects Appreciation.this is the file i used : https://www.printables.com/model/1131982-mac-se30-brightness-knob it was sitting in my cart for a few weeks.
-
JDW replied to the thread 3D Printing & MacEffects Appreciation.@caver01 , thank you! At this point, I should mention to everyone that my big reason to have an extra brightness knob is not merely for...
-
-
Ccaver01 replied to the thread 3D Printing & MacEffects Appreciation.I just deleted my .zip attached above and re-uploaded a new one with a brimmed version inside too.
-
JDW replied to the thread 3D Printing & MacEffects Appreciation.My concern is about the fit of even the original Knob you created in terms of tightness. How "tightly" does the original fit in terms...
-
Ccaver01 replied to the thread 3D Printing & MacEffects Appreciation.I like that animation! The 6.2 ID version was really for @wottle and his troubleshooting and possible group buy. I know its frustrating...
-
JDW replied to the thread 3D Printing & MacEffects Appreciation.@caver01 I downloaded your new STL. It only contains "Mac SE Brightness Knob Combined - 6.2 ID.stl". It does NOT also contain the...
-
-
Ccaver01 replied to the thread 3D Printing & MacEffects Appreciation.Did you use the 6.2mm inner diameter version I posted here just 14 minutes ago? Wottle and I are trying to work out some dimensional...
-
DDave928 replied to the thread 3D Printing & MacEffects Appreciation.placed my PCBWAY order for the clear resin variant of the parts i previously pictured. figured it was time to bite the bullet.
