Search results

I've come across a nice little Sparcstation 1+ but it has some pieces of the top case that have broken off - before I got it :) Luckily, I have the pieces and so I'd like to glue them back on to improve the cosmetics as best I can. I've had recommendations to use either MEK or Xylene as they...

Yes - that was me. Glad to hear the board is working well for you. I didn't think there would be any problems, but it's always nice to hear things are working OK and you are a "happy customer"! :)

If you use the Apple Portrait on that card, it will have a slight "shimmer" to it, I'm guessing due to the slight difference in refresh rates - 67Mhz vs 75Mhz IIRC. It does work though, since I had the same card at one time with the Apple display.

Looks like it's from a Sony Watchman

It was a great show - fun to see/meet everyone!

I have a 13"(?) Trinitron I got as a HS graduation present to take to college. It was also the monitor for my Apple ][+. No remote, woodgrain, a line of physical buttons for each channel, with little plastic inserts to show the channel numbers. Still works! I use it on my NES among other things.

I have one of these. Got it as a "surprise" in a lot of stuff. Smells horribly of bad caps- I havent turned it on. I need to get after it, but I'm a little intimidated based on the videos I've seen.

Sweet - thanks!

The trick on some drives is knowing which set of pins is 4, and which set is one. Thank $deity for old-age near-sightedness sometimes to try and read the markings!

Thanks for your note. The thing frustrated me so much I put it back on the shelf. This might get me to pull it out after VCFMW!

OK - so during this I had the original spinning disk in the machine (SCSI ID 1) while the BlueSCSI had a higher address (tried both 6 and 2). The BlueSCSI was in an external enclosure. Once I disconnected the internal drive so the BlueSCSI was the only thing on the bus, then it came up...

I'm trying to build an image for NeXT black hardware on BlueSCSI. Latest firmware. I've used both the NeXT tool to build disks as well as the image @Drake called out from Winworld that is said to work on BlueSCSI for NeXT. The image is seen by the NeXT as a drive, but in both cases its seen...

Always happy to have more working 50 pin SCSI drives! Good luck on the wiping!

It's the Rocket 33Mhz. I upped the OS on the IIci to System 7, and re-installed the RocketShare software I have (1.3.1) Everything came up roses! Now to decide if I'm going to keep it or not... If there's any interest out there, let me know.

The Garden seems to have the software I need, even for System 6, so some downloading seems to be in order...

Sorry 32MB of RAM. :) I have Rocketshare software disks that came with the card. I put the Rocket in my IICi that is running System 6. It seems the software I have must be for System 7 since it put a few extensions in the System folder just sitting around and there are no control panels etc...

I see posts elsewhere that the Rocket will only work in a IIfx with less than 32GB of RAM, and only in 24 bit mode. Also, it seems that System 7.1 is the limit for the Rocket. I guess I'll haul out the IIci since I don't want to pull RAM from the IIfx.

If I had a Radius Rocket to test out before I decide to sell it, what would be the best combo of OS and machine? I have a IIfx, a Q700, and a IIci that I could use as a testbed.

Or, maybe turn of flow control... DTR/DCD?

...and the G3 card! :)