Search results

Works for me

It is down at this time, and not just for Comcast.

About 2 weeks for "Global Standard Direct Line" shipping

Is it vibe coded?

is it this one by any chance? I haven't found any datasets specific to 68kMLA or its forum software on the main listing, while there is a set for many breached vBulletin boards 68kMLA isn't named in it

who what where why how?

Can it work on a Mac Plus? Is it as accurate as the original RTC?

If they're so good why don't you post them here or on the Internet Archive?

*ahem* "Last seen this week"

Hi, USB PD 3.1 supports up to 240W, should be plenty for a TAM. It can only output one voltage at a time, you would need a power supply that converts its 20-48 VDC into your +5V, +12V, -12V rails. And it would have to work with the soft-power switch...

Is there a broken connection inside the PSU?

https://en.wikipedia.org/wiki/Retrobright#Effectiveness

It's down again...

It would be very cool if this drive was reverse-engineered and new ones built. 1.44MB floppies on a Plus? The PEEL 18CV8P programmable logic chips used are supported by afterburner but are most likely read-protected and will need a special technique to dump them. As for the EPROM you can dump...

Affix to the end of each of your messages :)

This is what Goo Gone is for

I would prefer hot air... I've never owned a PowerMac and it isn't necessary. Just would like a more precise mechanical specification coming up so I know exactly where to place the footprints

Picture of hacksawed riser shows trace on slot B connecting all interrupt lines together. So I'm not sure why you'd think you've erred? I would like to start with schematics of a known-good riser. Even if your cable kludge worked, I'd rather do things by the book. If you need me to you may send...

Yeah, 0.01µF seems right. Are the purple pins on the illustration all GND?