restoration

  1. C

    Urgent answer needed, 800kb floppy disks in 1.44mb floppy drive?

    Hi all, I am not sure where this is meant to go so I will also be adding it into another section, but I am needing to know very soon whether or not a powerbook 170 floppy disk drive, will be able to read and install software from 800 kb floppy diskettes? I have found a listing on ebay for some...
  2. C

    Urgent answer needed, 800kb floppy disks in 1.44mb floppy drive?

    Hi all, I am not sure where this is meant to go so I will also be adding it into another section, but I am needing to know very soon whether or not a powerbook 170 floppy disk drive, will be able to read and install software from 800 kb floppy diskettes? I have found a listing on ebay for some...
  3. C

    Powerbook 170 battery rebuild. Guidance needed.

    Hi all I am currently still on the journey to restoring a powerbook 170 that I can use for retro/vintage mac shenanigans. Currently I have done the following: Bought a powerbook 170. Tested it out. Cleaned it. Did a complete teardown. Worked on repairs. Did some plastic welding, and super...
  4. estravolta

    Restoring SE/30 - Melted/damaged CRT power and CRT residue

    Hi all! I am working on restoring my first classic Mac, an SE/30. I've started to dive in and have ordered capacitors and such, cleaned it, taken out the PRAM battery, et cetera. I powered it up after giving it a good cleaning and got a relatively dim vertical line. Page 162 of Dead Mac Scrolls...
  5. Elemenoh

    PowerBook 5300c Recapping Guide

    The PowerBook 5300c has three circuit boards with electrolytic capacitors. The locations and specs may vary in other models such as the 5300ce and 5300cs. Location(s) Capacitance Voltage Pads (edge to edge) SMD Size Recommendation Notes INVERTER BOARD C3 10uF 50V 9.5mm C (6mm L)...
  6. wottle

    Color Classic Crash Chimes

    I picked up a Color Classic this past weekend and it would not boot at all. However, the fans would power up if I removed the logic board and plugged it in. I started looking closer at the board, which appeared to be in pretty good shape (PRAM battery had been removed, didn't notice any damage...