Search results

I am working on a classic II and have read over the posts here. Not able to determine what could be the issues on areas to check and what to change but I am not getting correct voltages from the analog board. It’s fully recapped. I am getting 10.28 instead of the 12 range. And for the 5v I am...

Got it. Easy enough. To the connector anchor point to ground.

So on the internal scsi connector says all odd pins are ground? Just want to confirm to be sure? Is there a closer location you would suggest so I not need to run a long wire on board underside?

Don’t know. i Have a new holder to install and it won’t hold solder. I tried. I am sure negative has to go to ground somewhere why I asking about a wire run to another connecting point.

Here are the images

When removing the battery holder, the negative side via completely came out. On either side of the board there is no visible trace of where it goes to put a trace repair or wire. I assume it’s inside the board so i can’t do much with it. Is there a contact point somewhere on the board I can run...

Evening to all. I have an Apple ii+ and the a2m2010 green monitor. The monitor had vertical collapse issue so I recapped it complete with a kit. All caps replaced along with IC601 that was under voltage. Now 601 is correct voltage I think. Someone can provide what it should be to confirm...